PLANET XGS3-24040 - Manual (Page 22)

Chapter 1 INTRODUCTION
1-4
− STP, IEEE 802.1d (Spanning Tree Protocol)
− RSTP, IEEE 802.1w (Rapid Spanning Tree Protocol)
− MSTP, IEEE 802.1s (Multiple Spanning Tree Protocol, spanning tree by VLAN)
 Support Link Aggregation
− 802.3ad Link Aggregation Control Protocol (LACP)
− Cisco ether-channel (Static Trunk)
− Maximum 8 trunk groups, up to 8 ports per trunk group
− Up to 16Gbps bandwidth(Duplex Mode)
 Provide Port Mirror (many-to-1)
 Port Mirroring to monitor the incoming or outgoing traffic on a particular port
 Quality of Service
 8 priority queues on all switch ports.
 Supports for strict priority and weighted round robin (WRR) CoS policies
 Ingress Shaper and Egress Rate Limit per port bandwidth control
 Traffic-policing policies based on application
 Multicast
 Supports IGMP Snoopingv1, v2 and v3
 Querier mode support
 Security
 IEEE 802.1x Port-Based network access authentication
 MAC-Based network access authentication
 IP-Based Access Control List (ACL)
 MAC-Based Access Control List
 Static MAC
 Management
 WEB-based, Telnet, Console Command Line management
 SSH( Secure Shell), SSL
 Accesses through SNMPv1, v2c and v3 security set and get requests.
 Four groups (history, statistics, alarms, and events) of embedded remote monitoring (RMON)
agents for network monitoring and traffic analysis
 Built-in Trivial File Transfer Protocol (TFTP) client
 BOOTP and DHCP for IP address assignment
 Firmware upload/download via HTTP / TFTP
 SNTP (Simple Network Time Protocol)
 LLDP Protocol
 Redundant Power System
 100~240V AC / 12V DC Dual power redundant
 Active-active redundant power failure protection
 Backup of catastrophic power failure on one supply