PLANET XGS3-24040 - Manual (Page 281)

Chapter 37 OSPF
37-5
Command Explanation
Global Mode
[no] router ospf [process <id>]
Enables OSPF protocol; the “no router
ospf” command disables OSPF protocol.
(required)
OSPF Protocol Configuration Mode
router-id
no router-id
Configures the ID number for the layer3
switch running OSPF; the “no router id”
command cancels the ID number. The IP
address of an interface is selected to be the
layer3 switch ID. (optional)
[no] network { |
/} area
Configure certain segment to certain area,
the no [no] network { |
/} area
command cancels this configuration.
(required)
2. Configure OSPF protocol parameters
（1）Configure OSPF packet sending mechanism parameters
1）Configure OSPF packet verification
2）Set the OSPF interface to receive only
3）Configure the cost for sending packets from the interface
Command Explanation
Interface Configuration Mode
ip ospf authentication
{ message-digest | null}
no ip ospf authentication
Configures the authentication method by the
interface to accept OSPF packets; the no ip
ospf authentication command restores the
default settings.
ip ospf authentication-key LINE
no ip ospf authentication-key
Configure the key of the authentication process
of OSPF data packets receiving for the
interfaces; the no action of this command
restores the default settings.
[no] passive-interface {IFNAME |
ethernet IFNAME | Vlan <ID>}
Sets an interface to receive only, the no
passive-interface {IFNAME | ethernet
IFNAME | Vlan <ID>} command cancels this
configuration.
ip ospf cost <cost >
no ip ospf cost
Sets the cost for running OSPF on the interface;
the “no ip ospf cost” command restores the
default setting.