PLANET XGS3-24040 - Manual (Page 285)

Chapter 37 OSPF
37-9
37.3 OSPF Examples
37.3.1 Configuration Example of OSPF
Scenario 1: OSPF autonomous system.
This scenario takes an OSPF autonomous system consists of five switch for example.
Figure 5-1 Network topology of OSPF autonomous system
The configuration for layer3 Switch1 and Switch5 is shown below:
Layer 3 Switch1
Configuration of the IP address for interface vlan1
Switch1#config
Switch1(config)# interface vlan 1
Switch1(config-if-vlan1)# ip address 10.1.1.1 255.255.255.0
Switch1(config-if-vlan1)#exit
Configuration of the IP address for interface vlan2
Configure the IP address of interface vlan2
Switch1(config)# interface vlan 2
Switch1(config-if-vlan2)# ip address 100.1.1.1 255.255.255.0
Switch1 (config-if-vlan2)#exit
Enable OSPF protocol, configure the area number for interface vlan1 and vlan2.
Switch1(config)#router ospf
Switch1(config-router)#network 10.1.1.0/24 area 0
Switch1(config-router)#network 100.1.1.0/24 area 0
Switch1(config-router)#exit
Switch1(config)#exit
Switch1#
SwitchA
SwitchB
SwitchE SwitchD
SwitchC
E1/2:10.1.1.1
vlan1
E1/1:10.1.1.2
vlan1
E1/1:100.1.1.1
vlan2
E1/1:100.1.1.2
vlan2
E1/2:20.1.1.1
vlan3
E1/1:20.1.1.2
vlan3
E1/2:30.1.1.1
vlan3
E1/1:30.1.1.2
vlan3
Area 0
Area 1