PLANET XGS3-24040 - Manual (Page 37)

XGS3 Configuration Guide
3-11
Figure 3-4 Opening HyperTerminal
4) COM1 property appears, select “9600” for “Baud rate”, “8” for “Data bits”, “none” for “Parity checksum”, “1”
for stop bit and “none” for traffic control; or, you can also click “Restore default” and click “OK”.
Figure 3-5 Opening HyperTerminal
Step 3: Entering switch CLI interface
Power on the switch, the following appears in the HyperTerminal windows, that is the CLI configuration mode
for Switch.