PLANET XGS3-24040 - Manual (Page 249)

Chapter 33 Routing Protocol Overview
33-4
As for relevant as-path configurations, please refer to the ip as-path command in BGP configuration.
5. community-list
Community-list is only for BGP. There is a community property field in the BGP routing messages packet for
identifying a community. The community list is for specifying matching conditions for Community-list field.
As for relevant Community-list configuration, please refer to the ip as-path command in BGP configuration
33.2.2 IP Routing Policy Configuration Task List
1． Define route-map
2． Define the match clause in route-map
3． Define the set clause in route-map
4． Define address prefix list
1. Define route-map
Command Explanation
Global mode
route-map {deny | permit}
no route-map [{deny | permit}
]
Configure route-map; the
no route-map
[{deny |
permit}
]
command deletes the
route-map.
2. Define the match clause in route-map
Command Explanation
Route-map configuration mode
match as-path
no match as-path []
Match the autonomous
system as path
access-list the BGP route
passes through; the no
match as-path
[] command
deletes match condition.
match community <community-list-name |
community-list-num > [exact-match]
no match community [<community-list-name |
community-list-num > [exact-match]]
Match a community
property access-list. The
no match community
[<community-list-name
| community-list-num >
[exact-match]]
command deletes match
condition.