PLANET XGS3-24040 - Manual (Page 357)

Chapter 43 Ipv4 Multicast Protocol
43-11
2) Configure the hold time for PIM-SM hello messages
Command Explanation
Interface Configuration Mode
ip pim hello-holdtime <value>
no ip pim hello-holdtime
To configure the value of the holdtime field in the
PIM-SM hello messages. The no form of this
command will restore the hold time to the default
value.
3) Configure ACL for PIM-SM neighbors
Command Explanation
Interface Configuration Mode
ip pim
neighbor-filter{<access-list-number
> }
no ip pim
neighbor-filter{<access-list-number
> }
To configure ACL to filter PIM-SM neighbors. If
session to the neighbor has been denied by
ACL, then the sessions that have been set up
will be discarded immediately and new sessions
will not be set up.
4) Configure the interface as the boundary interface of the PIM-SM protocol
Command Explanation
Interface Configuration Mode
ip pim bsr-border
no ip pim bsr-border
To configure the interface as the boundary of
PIM-SM protocol. On the boundary interface,
BSR messages will not be sent or received. The
network connected the interface is considered
as directly connected network. The no form of
this command will remove the configuration.
5) Configure the interface as the management boundary of the PIM-SM protocol
Command Explanation
Interface Configuration Mode
ip pim scope-border <1-99 > |
<acl_name>
no ip pim scope-border
To configure PIM-SM management boundary for
the interface and apply ACL for the management
boundary. With default settings, 239.0.0.0/8 is
considered as the scope of the management
group. If ACL is configured, then the scope
specified by ACL permit command is the scope
of the management group. acl_name should be
standard IPv4 ACL name. The no form of this
command will remove the configuration.