PLANET XGS3-24040 - Manual (Page 175)

Chapter 21 Layer 3 Forward Configuration
21-5
(13) Set the retrans-timer of sending router advertisement
(14) Set the flag representing whether information other than the address information will be obtained via
DHCPv6
(15) Set the flag representing whether the address information will be obtained via DHCPv6
3. IPv6 Tunnel configuration
(1) Create/Delete Tunnel
(2) Configure tunnel description
(3) Configure Tunnel Source
(4) Configure Tunnel Destination
(5) Configure Tunnel Next-Hop
(6) Configure Tunnel Mode
(7) Configure Tunnel Routing
1. IPv6 Basic Configuration
(1) Globally enable IPv6
Command Explanation
Global mode
ipv6 enable
no ipv6 enable
Enable functions such as IPv6 data packet
transmission, neighbor discovery, router
advertisement, routing protocol, etc. The NO
command disables IPv6 function.
(2) Configure interface IPv6 address
Command Explanation
Interface Configuration Mode
ipv6 address
<ipv6-address/prefix-length>
[eui-64]
no ipv6 address
<ipv6-address/prefix-length>
Configure IPv6 address, including aggregatable
global unicast addresses, site-local addresses
and link-local addresses. The no ipv6 address
<ipv6-address/prefix-length> command
cancels IPv6 address.
(3) Set IPv6 Static Routing
Command Explanation
Global mode