PLANET XGS3-24040 - Manual (Page 137)

Chapter 15 MAC Table Configuration
15-4
] [interface [ethernet |
portchannel] ]
15.3 Typical Configuration Examples
Figure 2-2 MAC Table typical configuration example
Scenario:
Four PCs as shown in the above figure connect to port 1/5、1/7、1/9、1/11 of switch, all the four PCs belong
to the default VLAN1. As required by the network environment, dynamic learning is enabled. PC1 holds
sensitive data and can not be accessed by any other PC that is in another physical segment; PC2 and PC3
have static mapping set to port 7 and port 9, respectively.
The configuration steps are listed below:
1. Set the MAC address 00-01-11-11-11-11 of PC1 as a filter address.
Switch(config)#mac-address-table static 00-01-11-11-11-11 discard vlan 1.
2. Set the static mapping relationship for PC2 and PC3 to port 7 and port 9, respectively.
Switch(config)#mac-address-table static 00-01-22-22-22-22 interface ethernet 1/7 vlan 1
Switch(config)#mac-address-table static 00-01-33-33-33-33 interface ethernet 1/9 vlan 1
1/7 1/9 1/11 1/5
PC1
MAC 00-01-11-11-11-11
PC4
MAC 00-01-44-44-44-44
PC3
MAC 00-01-33-33-33-33
PC2
MAC 00-01-22-22-22-22