PLANET XGS3-24040 - Manual (Page 221)

Chapter 29 DHCPv6 Configuration
29-3
（2）To configure parameter of DHCPv6 address pool
Command Explanation
DHCPv6 address pool Configuration
Mode
network-address
<ipv6-pool-start-address>
{<ipv6-pool-end-address> |
<prefix-length>} [eui-64]
no network-address
To configure the range of IPv6 address
assignable of address pool.
dns-server
no dns-server
To configure DNS server address for
DHCPv6 client.
domain-name
no domain-name
To configure DHCPv6 client domain name.
excluded-address
no excluded-address
To exclude IPv6 address which isn’t used for
dynamic assignment in address pool.
lifetime { | infinity}
{ | infinity}
no lifetime
To configure valid time or preferred time of
DHCPv6 address pool.
3. To enable DHCPv6 server function on port.
Command Explanation
Interface Configuration Mode
ipv6 dhcp server
[preference ] [rapid-commit]
[allow-hint]
no ipv6 dhcp server
To enable DHCPv6 server function on
specified port, and binding the used
DHCPv6 address pool.
29.3 DHCPv6 Relay Delegation Configuration
DHCPv6 relay delegation configuration task list as below:
1． To enable/disable DHCPv6 service
2． To configure DHCPv6 relay delegation on port
1. To enable DHCPv6 service
Command Explanation
Global Mode
service dhcpv6
no service dhcpv6
To enableDHCPv6 service.
2. To configure DHCPv6 relay delegation on port