PLANET XGS3-24040 - Manual (Page 59)

Chapter 4 Basic Switch Configuration
4-10
2. Configure SNMP community string
Command Explanation
Global Mode
snmp-server community {ro|rw} <string>
[access {|}]
[ipv6-access
{|}] [read
] [write
]
no snmp-server community
[access {|}]
[ipv6-access
{|}]
Configure the community string for the switch; the no
command deletes the configured community string.
3. Configure IP address of SNMP management base
Command Explanation
Global Mode
snmp-server securityip { |
}
no snmp-server securityip { |
}
Configure the secure IPv4/IPv6 address which is
allowed to access the switch on the NMS; the no
command deletes configured secure address.
snmp-server securityip enable
snmp-server securityip disable
Enable or disable secure IP address check function
on the NMS.
4. Configure engine ID
Command Explanation
Global Mode
snmp-server engineid
no snmp-server engineid
Configure the local engine ID on the switch. This
command is used for SNMP v3.
5. Configure user
Command Explanation
Global Mode
snmp-server user
[{authPriv | authNoPriv} auth {md5 | sha}
] [access {|}]
[ipv6-access {|}]
no snmp-server user [access
{|}] [ipv6-access
{|}]
Add a user to a SNMP group. This command is
used to configure USM for SNMP v3.