PLANET XGS3-24040 - Manual (Page 306)

Chapter 38 OSPFv3
38-11
 To startup OSPFv3 protocol (execute router IPv6 OSPF instruction), and configure affiliated OSPFv3
area on relative interface.
 And then, consider OSPFv3 protocol characteristic —— OSPFv3 backbone area (area 0) must be
continuous. If it doesn’t ensure that virtual link is implemented continuously, all of not area 0 only can be
connected by area 0 and other not area 0, not directly connected by not area 0; The border Layer 3
switch is a part of this Layer 3 switch interface belongs to area 0, and another part of interface belongs
to not area 0; for multi-access net etc like broadcast, Layer 3 switch DR needs vote and appoint; for
each OSPFv3 process must not configure router ID of 0.0.0.0 address.