PLANET XGS3-24040 - Manual (Page 507)

Chapter 54 IPv6 Security RA Configuration
54-1
Chapter 54 IPv6 Security RA Configuration
54.1 Introduction to IPv6 Security RA
In IPv6 networks, the network topology is generally compromised of routers, layer-two switches and IPv6
hosts. Routers usually advertise RA, including link prefix, link MTU and other information, when the IPv6 hosts
receive RA, they will create link address, and set the default router as the one sending RA in order to
implement IPv6 network communication. If a vicious IPv6 host sends RA to cause that normal IPv6 users set
the default router as the vicious IPv6 host user, the vicious user will be able to capture the information of other
users, which will threat the network security. Simultaneously, the normal users get incorrect address and will
not be able to connect to the network. So, in order to implement the security RA function, configuring on the
switch ports to reject vicious RA messages is necessary, thus to prevent forwarding vicious RA to a certain
extent and to avoid affecting the normal operation of the network.
54.2 IPv6 Security RA Configuration Task Sequence
1. Globally enable IPv6 security RA
2. Enable IPv6 security RA on a port
3. Display and debug the relative information of IPv6 security RA
1. Globally enable IPv6 security RA
Command Explanation
Global Configuration Mode
ipv6 security-ra enable
no ipv6 security-ra enable
Globally enable and disable IPv6 security
RA.
2. Enable IPv6 security RA on a port
Command Explanation
Port Configuration Mode
ipv6 security-ra enable
no ipv6 security-ra enable
Enable and disable IPv6 security RA in port
configuration mode.
3. Display and debug the relative information of IPv6 security RA
Command Explanation
Admin Mode