H3C Technologies H3C SR8800 - Manual (Page 68)

57
Step Command Remarks
4. Return to system view. quit N/A
5. Enter the interface view of an
MPLS TE link.
interface interface-type
interface-number
N/A
6. Enable interface MPLS TE. mpls te Disabled by default
7. Return to system view. quit ––
8. Create a tunnel interface and
enter its view.
interface tunnel tunnel-number N/A
9. Assign an IP address to the
tunnel interface.
ip address ip-address netmask Optional
10. Set the tunnel protocol to
MPLS TE.
tunnel-protocol mpls te N/A
11. Configure the destination
address of the tunnel.
destination ip-address N/A
12. Configure the tunnel ID of the
tunnel.
mpls te tunnel-id tunnel-id N/A
13. Submit the current tunnel
configuration.
mpls te commit N/A
NOTE:
For more information about tunnel interfaces, see Layer 3—IP Services Configuration Guide.
Configuring DiffServ-aware TE
To configure DS-TE:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter MPLS view. mpls N/A
3. Configure the DS-TE mode as
IETF.
mpls te ds-te mode ietf
Optional.
By default, the DS-TE mode is
prestandard.
4. Configure the BC model of
IETF DS-TE as MAM.
mpls te ds-te ietf bc-mode mam
Optional.
By default, the BC model of IETF
DS-TE is RDM.
5. Configure the TE class
mapping in IETF DS-TE mode,
that is, the TE class-CT-priority
association.
mpls te ds-te ietf te-class
te-class-index class-type
class-type-number priority
pri-number
Optional.
By default, the TE class mappings
in IETF mode are shown as
Table
1 .
Table 1 Default TE class mappings in IETF mode
TE Class CT Priority
0 0 7