H3C Technologies H3C SR8800 - Manual (Page 189)

178
# Configure interface GigabitEthernet 3/1/2, bind VPLS instance aaa to the interface, and
specify the attached CE as a spoke-CE.
[Spoke-PE2] interface GigabitEthernet 3/1/2
[Spoke-PE2-GigabitEthernet3/1/2] l2 binding vsi aaa spoke
[Spoke-PE2-GigabitEthernet3/1/2] quit
4. Configure Hub-PE.
# Configure basic MPLS.
system-view
[Sysname] sysname Hub-PE
[Hub-PE] interface loopback 0
[Hub-PE-LoopBack0] ip address 3.3.3.9 32
[Hub-PE-LoopBack0] quit
[Hub-PE] mpls lsr-id 3.3.3.9
[Hub-PE] mpls
[Hub-PE–mpls] quit
[Hub-PE] mpls ldp
[Hub-PE–mpls-ldp] quit
# Configure basic MPLS on the interface connected to Spoke-PE 1.
[Hub-PE] interface GigabitEthernet 3/1/1
[Hub-PE-GigabitEthernet3/1/1] ip address 10.1.1.2 24
[Hub-PE-GigabitEthernet3/1/1] mpls
[Hub-PE-GigabitEthernet3/1/1] mpls ldp
[Hub-PE-GigabitEthernet3/1/1] quit
# Configure basic MPLS on the interface connected to Spoke-PE 2.
[Hub-PE] interface GigabitEthernet 3/1/2
[Hub-PE-GigabitEthernet3/1/2] ip address 20.1.1.2 24
[Hub-PE-GigabitEthernet3/1/2] mpls
[Hub-PE-GigabitEthernet3/1/2] mpls ldp
[Hub-PE-GigabitEthernet3/1/2] quit
# Configure the remote LDP sessions.
[Hub-PE] mpls ldp remote-peer 1
[Hub-PE-mpls-remote-1] remote-ip 1.1.1.9
[Hub-PE-mpls-remote-1] quit
[Hub-PE] mpls ldp remote-peer 2
[Hub-PE-mpls-remote-2] remote-ip 2.2.2.9
[Hub-PE-mpls-remote-2] quit
# Enable L2VPN and MPLS L2VPN.
[Hub-PE] l2vpn
[Hub-PE-l2vpn] mpls l2vpn
[Hub-PE-l2vpn] quit
# Configure the LDP VPLS instance aaa that supports the hub-spoke model, and configure the peers
as spokes.
[Hub-PE] vsi aaa static hub-spoke
[Hub-PE-vsi-aaa] pwsignal ldp
[Hub-PE-vsi-aaa-ldp] vsi-id 500
[Hub-PE-vsi-aaa-ldp] peer 1.1.1.9 spoke
[Hub-PE-vsi-aaa-ldp] peer 2.2.2.9 spoke