H3C Technologies H3C SR8800 - Manual (Page 145)

134
# Configure the maximum bandwidth and bandwidth constraints on Router C.
[RouterC] interface GigabitEthernet 3/1/1
[RouterC-GigabitEthernet3/1/1] mpls te max-link-bandwidth 10000
[RouterC-GigabitEthernet3/1/1] mpls te max-reservable-bandwidth rdm 10000 bc1 8000
bc2 5000 bc3 2000
[RouterC-GigabitEthernet3/1/1] quit
[RouterC] interface POS 2/1/1
[RouterC-POS2/1/1] mpls te max-link-bandwidth 10000
[RouterC-POS2/1/1] mpls te max-reservable-bandwidth rdm 10000 bc1 8000 bc2 5000 bc3
2000
[RouterC-POS2/1/1] quit
# Configure the maximum bandwidth and bandwidth constraints on Router D.
[RouterD] interface GigabitEthernet 3/1/1
[RouterD-GigabitEthernet3/1/1] mpls te max-link-bandwidth 10000
[RouterD-GigabitEthernet3/1/1] mpls te max-reservable-bandwidth rdm 10000 bc1 8000
bc2 5000 bc3 2000
[RouterD-GigabitEthernet3/1/1] quit
6. Create an MPLS TE tunnel
# Create an MPLS TE tunnel on Router A.
[RouterA] interface tunnel 1
[RouterA-Tunnel1] ip address 7.1.1.1 255.255.255.0
[RouterA-Tunnel1] tunnel-protocol mpls te
[RouterA-Tunnel1] destination 4.4.4.9
[RouterA-Tunnel1] mpls te tunnel-id 10
[RouterA-Tunnel1] mpls te signal-protocol rsvp-te
[RouterA-Tunnel1] mpls te bandwidth ct2 4000
[RouterA-Tunnel1] mpls te priority 0
[RouterA-Tunnel1] mpls te commit
[RouterA-Tunnel1] quit
7. Verify the configuration
# Execute the display interface tunnel command on Router A. You see that the tunnel interface is
up.
[RouterA] display interface tunnel
Tunnel1 current state: UP
Line protocol current state: UP
Description: Tunnel1 Interface
The Maximum Transmit Unit is 64000
Internet Address is 7.1.1.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID not set
Tunnel source unknown, destination 4.4.4.9
Tunnel protocol/transport CR_LSP
Output queue : (Urgent queuing : Size/Length/Discards) 0/100/0
Output queue : (Protocol queuing : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
Last 300 seconds input: 0 bytes/sec, 0 packets/sec
Last 300 seconds output: 0 bytes/sec, 0 packets/sec
0 packets input, 0 bytes
0 input error