H3C Technologies H3C SR8800 User Manual

Page 225

214

# Enable L2VPN and MPLS L2VPN.

[PE1] l2vpn

[PE1-l2vpn] mpls l2vpn

[PE1-l2vpn] quit

# Enable LDP globally.

[PE1] mpls ldp

[PE1-mpls-ldp] quit

# Configure the peer relationship with PE 2 so that the LDP remote session can be established
between them.

[PE1] mpls ldp remote-peer 1

[PE1-mpls-ldp-remote-1] remote-ip 192.3.3.3

[PE1-mpls-ldp-remote-1] quit

# Configure the interface connected with the P router, namely GigabitEthernet 4/1/2, and enable
LDP on the interface.

[PE1] interface GigabitEthernet4/1/2

[PE1-GigabitEthernet4/1/2] ip address 10.1.1.1 24

[PE1-GigabitEthernet4/1/2] mpls

[PE1-GigabitEthernet4/1/2] mpls ldp

[PE1-GigabitEthernet4/1/2] quit

# Configure OSPF on PE 1 for establishing LSPs.

[PE1] ospf

[PE1-ospf-1] area 0

[PE1-ospf-1-area-0.0.0.0] network 10.1.1.1 0.0.0.255

[PE1-ospf-1-area-0.0.0.0] network 192.2.2.2 0.0.0.0

[PE1-ospf-1-area-0.0.0.0] quit

[PE1-ospf-1] quit

# On the interface connecting CE 1, namely GigabitEthernet 4/1/1, create a Martini MPLS
L2VPN connection. The interface requires no IP address.

[PE1] interface GigabitEthernet4/1/1

[PE1-GigabitEthernet4/1/1] mpls l2vc 192.3.3.3 101

[PE1-GigabitEthernet4/1/1] quit

Configure the P router.
# Configure the LSR ID and enable MPLS globally.

system-view

[Sysname] sysname P

[P] interface loopback 0

[P-LoopBack0] ip address 192.4.4.4 32

[P-LoopBack0] quit

[P] mpls lsr-id 192.4.4.4

[P] mpls

# Enable LDP globally.

[P] mpls ldp

[P-mpls-ldp] quit

# Configure the interface connected with PE 1, namely GigabitEthernet 4/1/1, and enable LDP
on the interface.

[P] interface GigabitEthernet4/1/1

[P-GigabitEthernet4/1/1] ip address 10.1.1.2 24

This manual is related to the following products: