H3C Technologies H3C SR8800 - Manual (Page 161)

150
Outgoing Tunnel ID : 0x0
Label Operation : POP
------------------------------------------------------------------
LSP Information: LDP LSP
------------------------------------------------------------------
No : 3
VrfIndex :
Fec : 2.2.2.2/32
Nexthop : 127.0.0.1
In-Label : 3
Out-Label : NULL
In-Interface : POS2/1/2
Out-Interface : ----------
LspIndex : 10241
Tunnel ID : 0x0
LsrType : Egress
Outgoing Tunnel ID : 0x0
Label Operation : POP
No : 4
VrfIndex :
Fec : 3.3.3.3/32
Nexthop : 10.0.0.2
In-Label : NULL
Out-Label : 3
In-Interface : ----------
Out-Interface : POS2/1/2
LspIndex : 10242
Tunnel ID : 0x22000
LsrType : Ingress
Outgoing Tunnel ID : 0x0
Label Operation : PUSH
# Perform the display interface tunnel command on PE 1. The output shows that traffic is being
forwarded along the CR-LSP of the TE tunnel.
[PE1] display interface tunnel 4
Tunnel1 current state: UP
Line protocol current state: UP
Description: Tunnel1 Interface
The Maximum Transmit Unit is 1500
Internet Address is 12.1.1.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID not set
Tunnel source unknown, destination 3.3.3.3
Tunnel protocol/transport CR_LSP
Output queue : (Urgent queuing : Size/Length/Discards) 0/100/0
Output queue : (Protocol queuing : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
Last 300 seconds input: 5 bytes/sec, 0 packets/sec
Last 300 seconds output: 5 bytes/sec, 0 packets/sec