H3C Technologies H3C SR8800 User Manual
Page 44
33
[RouterA] interface Pos 2/1/1
[RouterA-Pos2/1/1] mpls
[RouterA-Pos2/1/1] quit
# Configure MPLS on Router B.
[RouterB] mpls lsr-id 2.2.2.9
[RouterB] mpls
[RouterB-mpls] quit
[RouterB] interface Pos 2/1/1
[RouterB-Pos2/1/1] mpls
[RouterB-Pos2/1/1] quit
[RouterB] interface Pos 2/1/2
[RouterB-Pos2/1/2] mpls
[RouterB-Pos2/1/2] quit
# Configure MPLS on Router C.
[RouterC] mpls lsr-id 3.3.3.9
[RouterC] mpls
[RouterC-mpls] quit
[RouterC] interface Pos 2/1/1
[RouterC-Pos2/1/1] mpls
[RouterC-Pos2/1/1] quit
4.
Configure a static LSP from Router A to Router C.
# Configure the LSP ingress, Router A.
[RouterA] static-lsp ingress AtoC destination 21.1.1.0 24 nexthop 10.1.1.2 out-label
30
# Configure the LSP transit node, Router B.
[RouterB] static-lsp transit AtoC incoming-interface Pos 2/1/1 in-label 30 nexthop
20.1.1.2 out-label 50
# Configure the LSP egress, Router C.
[RouterC] static-lsp egress AtoC incoming-interface Pos 2/1/1 in-label 50
5.
Create a static LSP from Router C to Router A.
# Configure the LSP ingress, Router C.
[RouterC] static-lsp ingress CtoA destination 11.1.1.0 24 nexthop 20.1.1.1 out-label
40
# Configure the LSP transit node, Router B.
[RouterB] static-lsp transit CtoA incoming-interface Pos 2/1/2 in-label 40 nexthop
10.1.1.1 out-label 70
# Configure the LSP egress, Router A.
[RouterA] static-lsp egress CtoA incoming-interface Pos 2/1/1 in-label 70
6.
Verify the configuration.
# Execute the display mpls static-lsp command on each router to view the static LSP information.
The following takes Router A as an example:
[RouterA] display mpls static-lsp
total statics-lsp : 2
Name FEC I/O Label I/O If State
AtoC 21.1.1.0/24 NULL/30 -/Pos2/1/1 Up
CtoA -/- 70/NULL Pos2/1/1/- Up