H3C Technologies H3C SR8800 - Manual (Page 370)

359
Step Command Remarks
6. Enable the exchange of
BGP-VPNv6 routing
information with the specified
peer.
peer ip-address enable
By default, BGP peers exchange
only IPv4 routing information.
Configuring routing features for the BGP-VPNv6 subaddress
family
A variety of routing features for the BGP-VPNv6 subaddress family are the same as those for BGP IPv6
unicast routing. You can select any of the features as required.
To configure routing features for the BGP-VPNv6 subaddress family:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Configure the remote PE as
the peer. peer ip-address as-number
as-number
Required
4. Specify the interface for TCP
connections.
peer ip-address connect-interface
interface-type interface-number
Required
5. Enter BGP-VPNv6 subaddress
family view.
ipv6-family vpnv6 N/A
6. Set the default value of the
local preference.
default local-preference value
Optional
100 by default
7. Set the default value for the
system MED.
default med med-value
Optional
By default, the default value of the
system MED is 0.
8. Configure a filtering policy to
filter routes to be advertised.
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
export [ direct | isisv6 process-id |
ripng process-id | static ]
Optional
By default, the PE does not filter
routes to be advertised.
9. Configure a filtering policy to
filter received routes.
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
import Optional
By default, the PE does not filter
received routes.
10. Apply a filtering policy for the
peer.
peer ip-address filter-policy
acl6-number { export | import }
Optional
By default, no filtering policy is
applied for a peer.
11. Apply an IPv6-prefix list for
the peer to filter
received/advertised routes.
peer ip-address ipv6-prefix
prefix-name { export | import }
Optional
By default, no IPv6 prefix list is
applied for a peer.
12. Specify the preference value
for the routes received from
the peer.
peer ip-address preferred-value
value Optional
0 by default