H3C Technologies H3C SR8800 - Manual (Page 231)

220
system-view
[Sysname] sysname PE
[PE] l2vpn
[PE-l2vpn] mpls l2vpn
[PE-l2vpn] quit
[PE] mpls l2vpn vpn1 encapsulation ethernet
[PE-mpls-l2vpn-vpn1] route-distinguisher 100:1
[PE-mpls-l2vpn-vpn1] vpn-target 111:1
[PE-mpls-l2vpn-vpn1] ce ce1 id 1
[PE-mpls-l2vpn-ce-vpn1-ce1] connection ce-offset 2 interface GigabitEthernet4/1/1
[PE-mpls-l2vpn-ce-vpn1-ce1] quit
[PE-mpls-l2vpn-vpn1] ce ce2 id 2
[PE-mpls-l2vpn-ce-vpn1-ce2] connection ce-offset 1 interface GigabitEthernet4/1/2
[PE-mpls-l2vpn-vpn1] quit
2. Verify your configuration.
# Issue the display mpls l2vpn connection command on the PE. The output shows that two local
L2VPN connections are established and in up state.
[PE] display mpls l2vpn connection
2 total connections,
connections: 2 up, 0 down, 2 local, 0 remote, 0 unknown
VPN name: vpn1,
2 total connections,
connections: 2 up, 0 down, 2 local, 0 remote, 0 unknown
CE name: ce1, id: 1,
Rid type status peer-id route-distinguisher intf
2 loc up --- --- GigabitEthernet4/1/1
CE name: ce2, id: 2,
Rid type status peer-id route-distinguisher intf
1 loc up --- --- GigabitEthernet4/1/2
# Ping CE 2 from CE 1. The output shows that CE 1 and CE 2 can ping each other.
[CE1] ping 30.1.1.2
PING 30.1.1.2: 56 data bytes, press CTRL_C to break
Reply from 30.1.1.2: bytes=56 Sequence=1 ttl=255 time=90 ms
Reply from 30.1.1.2: bytes=56 Sequence=2 ttl=255 time=77 ms
Reply from 30.1.1.2: bytes=56 Sequence=3 ttl=255 time=34 ms
Reply from 30.1.1.2: bytes=56 Sequence=4 ttl=255 time=46 ms
Reply from 30.1.1.2: bytes=56 Sequence=5 ttl=255 time=94 ms
--- 30.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 34/68/94 ms