H3C Technologies H3C SR8800 - Manual (Page 348)

337
# Configure UPE 2 to establish MP-IBGP peer relationship with SPE 2 and to inject VPN routes.
[UPE2] bgp 100
[UPE2-bgp] peer 3.3.3.9 as-number 100
[UPE2-bgp] peer 3.3.3.9 connect-interface loopback 0
[UPE2-bgp] ipv4-family vpnv4
[UPE2-bgp-af-vpnv4] peer 3.3.3.9 enable
[UPE2-bgp-af-vpnv4] quit
[UPE2-bgp] ipv4-family vpn-instance vpn1
[UPE2-bgp-vpn1] peer 10.1.1.1 as-number 65430
[UPE2-bgp-vpn1] import-route direct
[UPE2-bgp-vpn1] quit
[UPE2-bgp] ipv4-family vpn-instance vpn2
[UPE2-bgp-vpn1] peer 10.3.1.1 as-number 65440
[UPE2-bgp-vpn1] import-route direct
[UPE2-bgp-vpn1] quit
[UPE2-bgp] quit
5. Configure CE 3
system-view
[CE3] interface GigabitEthernet 4/1/1
[CE3-GigabitEthernet4/1/1] ip address 10.1.1.1 255.255.255.0
[CE3-GigabitEthernet4/1/1] quit
[CE3] bgp 65430
[CE3-bgp] peer 10.1.1.2 as-number 100
[CE3-bgp] import-route direct
[CE3] quit
6. Configure CE 4
system-view
[CE4] interface GigabitEthernet 4/1/1
[CE4-GigabitEthernet4/1/1] ip address 10.3.1.1 255.255.255.0
[CE4-GigabitEthernet4/1/1] quit
[CE4] bgp 65440
[CE4-bgp] peer 10.3.1.2 as-number 100
[CE4-bgp] import-route direct
[CE4] quit
7. Configure SPE 1
# Configure basic MPLS and MPLS LDP to establish LDP LSPs.
system-view
[SPE1] interface loopback 0
[SPE1-LoopBack0] ip address 2.2.2.9 32
[SPE1-LoopBack0] quit
[SPE1] mpls lsr-id 2.2.2.9
[SPE1] mpls
[SPE1-mpls] quit
[SPE1] mpls ldp
[SPE1-mpls-ldp] quit
[SPE1] interface GigabitEthernet 4/1/1
[SPE1-GigabitEthernet4/1/1] ip address 172.1.1.2 24