H3C Technologies H3C SR8800 User Manual

Page 182

171

[PE1-vsi-bbb] pwsignal bgp

[PE1-vsi-bbb-bgp] route-distinguisher 100:1

[PE1-vsi-bbb-bgp] vpn-target 111:1

[PE1-vsi-bbb-bgp] site 1 range 10

[PE1-vsi-bbb-bgp] quit

[PE1-vsi-bbb] quit

# Configure interface GigabitEthernet 3/1/2 and bind VPLS instance aaa or bbb to the interface.

[PE1] interface GigabitEthernet3/1/2

// To bind VPLS instance aaa to interface GigabitEthernet 3/1/2:

[PE1-GigabitEthernet3/1/2] l2 binding vsi aaa

// To bind VPLS instance bbb to interface GigabitEthernet 3/1/2:

[PE1-GigabitEthernet3/1/2] l2 binding vsi bbb

[PE1-GigabitEthernet3/1/2] quit

Configure PE 2.
# Configure the IGP protocol, such as OSPF. (Details not shown)
# Configure basic MPLS.

system-view

[Sysname] sysname PE2

[PE2] interface loopback 0

[PE2-LoopBack0] ip address 2.2.2.9 32

[PE2-LoopBack0] quit

[PE2] mpls lsr-id 2.2.2.9

[PE2] mpls

[PE1-mpls] quit

[PE2] mpls ldp

[PE2-mpls-ldp] quit

# Configure interface GigabitEthernet 3/1/1.

[PE2] interface GigabitEthernet 3/1/1

[PE2-GigabitEthernet3/1/1] ip address 10.10.10.11 24

# Configure basic MPLS on the interface.

[PE2-GigabitEthernet3/1/1] mpls

[PE2-GigabitEthernet3/1/1] mpls ldp

[PE2-GigabitEthernet3/1/1] quit

# Configure the remote LDP session.

[PE2] mpls ldp remote-peer 2

[PE2-mpls-remote-2] remote-ip 1.1.1.9

[PE2-mpls-remote-2] quit

# Configure BGP extensions.

[PE2] bgp 100

[PE2-bgp] peer 1.1.1.9 as-number 100

[PE2-bgp] peer 1.1.1.9 connect-interface loopback 0

[PE2-bgp] vpls-family

[PE2-bgp-af-vpls] peer 1.1.1.9 enable

[PE2-bgp-af-vpls] quit

[PE2-bgp] quit

# Enable L2VPN and MPLS L2VPN.

This manual is related to the following products: