H3C Technologies H3C SR8800 - Manual (Page 377)

366
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Configure the MCE as the
EBGP peer. peer ipv6-address as-number
as-number
Required
5. Redistribute the IGP routes of
the VPN.
import-route protocol [ process-id
[ med med-value | route-policy
route-policy-name ] * ]
Optional
By default, no route redistribution
is configured.
A VPN site must advertise the IPv6
VPN network addresses it can
reach to the connected MCE.
Configuring routing between MCE and PE
MCE-PE routing configuration includes these tasks:
• Bind the MCE-PE interfaces to IPv6 VPN instances
• Perform routing configurations
• Redistribute IPv6 VPN routes into the routing protocol running between the MCE and the PE.
NOTE:
Configurations in this section are configured on the MCE. Configurations on the PE are similar to those on
the PE in common IPv6 MPLS L3VPN network solutions (see “
Configuring routing between PE and CE ”).
Configuring IPv6 static routing between MCE and PE
To configure static routing between MCE and PE:
Step Command Remarks
1. Enter system
view.
system-view N/A
2. Configure
static routes
for an IPv6
VPN
instanceN/A.
ipv6 route-static ipv6-address prefix-length { interface-type
interface-number [ next-hop-address ] | next-hop-address |
vpn-instance d-vpn-instance-name nexthop-address } [ preference
preference-value ] Required
User either
command.
ipv6 route-static vpn-instance s-vpn-instance-name&<1-6>
ipv6-address prefix-length { interface-type interface-number
[ next-hop-address ] | nexthop-address [ public ] | vpn-instance
d-vpn-instance-name nexthop-address } [ preference
preference-value ]
3. Configure the
default
precedence
for static
routes.
ipv6 route-static default-preference default-preference-value
Optional
60 by default