H3C Technologies H3C SR8800 - Manual (Page 379)

368
Step Command Remarks
8. Enable the OSPFv3 process
on the interface. ospfv3 process-id area area-id
[ instance instance-id ]
Disabled by default.
NOTE:
For more information about OSPFv3, see Layer 3—IP Routing Configuration Guide.
Configuring IPv6 IS-IS between MCE and PE
To configure IPv6 IS-IS between MCE and PE:
Step Command Remarks
1. Enter system view. system-view N/A
2. Create an IS-IS process
for an IPv6 VPN
instance and enter IS-IS
view.
isis [ process-id ] vpn-instance
vpn-instance-name
Required
3. Configure a network
entity title.
network-entity net Not configured by default.
4. Enable the IPv6
capacity for the IS-IS
process.
ipv6 enable Disabled by default.
5. Redistribute the VPN
routes.
ipv6 import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost | [ level-1 |
level-1-2 | level-2 ] | route-policy
route-policy-name | tag tag ] *
Optional
By default, IS-IS does not
redistribute routes of any other
routing protocol.
If you do not specify the route level
in the command, the command will
redistribute routes to the level-2
routing table by default.
6. Configure a filtering
policy to filter the
redistributed routes.
ipv6 filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name |
route-policy route-policy-name } export
[ protocol [ process-id ] ]
Optional
By default, IPv6 IS-IS does not filter
redistributed routes.
7. Return to system view. quit N/A
8. Enter interface view. interface interface-type interface-number N/A
9. Enable IPv6 for the IS-IS
process on the
interface.
isis ipv6 enable [ process-id ] Disabled by default.
NOTE:
For more information about IPv6 IS-IS, see Layer 3—IP Routing Configuration Guide.
Configuring EBGP between MCE and PE
To configure EBGP between MCE and PE: