H3C Technologies H3C SR8800 - Manual (Page 211)

200
To create a Kompella local connection, you only need to configure the VPN and CE connection on the
PE. Neither IGP nor BGP L2VPN capability is required.
Configuration prerequisites
Before configuring Kompella MPLS L2VPN, complete the following tasks:
• Configure an IGP on the PEs and P routers to ensure IP connectivity within the MPLS backbone
• Configure basic MPLS and MPLS LDP on the PEs and P routers to establish LDP LSPs
• Enable MPLS L2VPN on the PEs
To configure Kompella MPLS L2VPN, prepare the following data:
• AS numbers of the local PE and the peer PE
• Name, RD, and VPN Target attributes of the L2VPN connection
• CE name, CE ID, and CE range
• CE offset
Configuration procedure
Configuring BGP L2VPN capability
To configure BGP L2VPN capability:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Establish the peer relationship
with the peer PE. peer { group-name | ip-address }
as-number as-number
N/A
4. Specify the interface for the
TCP connection.
peer { group-name | ip-address }
connect-interface interface-type
interface-number
N/A
5. Enter BGP L2VPN address
family view.
l2vpn-family N/A
6. Enable the filtering by the
VPN target extended
community attributes for the
received routing information.
policy vpn-target
Optional
Enabled by default
7. Enable the specified peer or
peers to exchange BGP
routing information of the
BGP-L2VPN address family.
peer { group-name | ip-address }
enable
N/A
NOTE:
For information about the configuration of BGP-L2VPN address family, see the chapter “Configuring
MPLS L3VPN.”
Configuring VPN
To configure VPN: