H3C Technologies H3C SR8800 - Manual (Page 50)

39
[RouterC-mpls-lspv] quit
3. Verify the configuration.
Execute the display mpls lsp bfd command on Router A and Router C to view information about
BFD sessions established for LSPs. Take Router A as an example:
[RouterA] display mpls lsp bfd
MPLS BFD Session(s) Information
-----------------------------------------------------------------------------
FEC : 11.1.1.0/24 Type : LSP
Local Discr : 130 Remote Discr : 130
Tunnel ID : --- NextHop : ---
Session State : Up Source IP : 3.3.3.9
Session Role : Passive
FEC : 21.1.1.0/24 Type : LSP
Local Discr : 129 Remote Discr : 129
Tunnel ID : 0x6040000 NextHop : 10.1.1.2
Session State : Up Source IP : 1.1.1.9
Session Role : Active
Total Session Num: 2
The output indicates that two BFD sessions have been established between 11.1.1.0/24 and
21.1.1.0/24: one for detecting the connectivity of the LSP from 1.1.1.0/24 to 21.1.1.0/24, and
the other for detecting the connectivity of the LSP from 21.1.1.0/24 to 1.1.1.0/24.
Use the following command to view the verbose information of the BFD sessions:
[RouterA] display bfd session verbose
Total session number: 2 Up session number: 2 Init mode: Active
IPv4 session working under Ctrl mode:
Local Discr: 129 Remote Discr: 129
Source IP: 1.1.1.9 Destination IP: 127.0.0.1
Session State: Up Interface: LoopBack0
Min Trans Inter: 400ms Act Trans Inter: 400ms
Min Recv Inter: 400ms Act Detect Inter: 2000ms
Recv Pkt Num: 18 Send Pkt Num: 18
Hold Time: 1900ms Connect Type: Indirect
Running Up for: 00:02:36 Auth mode: None
Protocol: MFW/LSPV
Diag Info: No Diagnostic
Local Discr: 130 Remote Discr: 130
Source IP: 1.1.1.9 Destination IP: 3.3.3.9
Session State: Up Interface: LoopBack0
Min Trans Inter: 400ms Act Trans Inter: 400ms
Min Recv Inter: 400ms Act Detect Inter: 2000ms
Recv Pkt Num: 18 Send Pkt Num: 18