H3C Technologies H3C SR8800 - Manual (Page 209)

198
NOTE:
•
Do not configure services other than L2VPN for the VLAN that is bound to the private network side of the
MPLS L2VPN.
• Do not enable port-based protocols such as STP, Ethernet OAM, 802.1X, GVRP, LLDP, DLDP, and LACP
on a port enabled with MPLS L2VPN.
• For an MPLS L2VPN connection created for a service instance, if the access mode of the service instance
is Ethernet, do not use a trunk port to connect the private network side. You can add this port to the
access VLAN as an access port, or configure the port as a hybrid port that permits packets from the
access VLAN to pass with the VLAN tag stripped.
If you create a Martini MPLS L2VPN connection on a VLAN interface, all packets carrying the tag of the
VLAN will be forwarded through the MPLS L2VPN connection, no matter from which Layer 2 Ethernet
ports the packets are received. That is, the router chooses an MPLS L2VPN connection for a received
packet according to only the VLAN tag carried in the packet. This not only wastes the Layer 2 Ethernet
port and VLAN resources but also mixes the users and services of different Layer 2 Ethernet ports.
To solve the problem, you can create a Martini MPLS L2VPN connection in a service instance. More
specifically:
1. Create a service instance on a Layer 2 Ethernet port.
2. Specify a packet matching VLAN ID for the service instance.
3. Create a Martini MPLS L2VPN connection in the service instance view.
Then, packets arriving at the Layer 2 Ethernet port and carrying the specified VLAN ID will be forwarded
by the MPLS L2VPN connection.
Configuration prerequisites
Before you configure Martini MPLS L2VPN, complete the following tasks:
• Configure an IGP on the PEs and P routers to ensure IP connectivity within the MPLS backbone
• Configure basic MPLS and MPLS LDP on the PEs and P routers to establish LDP LSPs
• Enable MPLS L2VPN on the PEs
To configure Martini MPLS L2VPN, prepare the following data:
• Types and numbers of the interfaces connecting the CEs
• Destination address of the L2VPN connection and the PW ID
• PW class template
Configuration procedure
To create a Martini MPLS L2VPN connection in a service instance:
Step Command Remarks
1. Enter system view. system-view N/A
2. Create a PW class
template and enter PW
class template view.
pw-class pw-class-name
Optional.
By default, no PW class template
is created.
3. Specify the PW
transport mode.
trans-mode { ethernet | vlan }
Optional.
VLAN by default.