H3C Technologies H3C SR8800 - Manual (Page 365)

354
Step Command Remarks
7. Apply an export routing
policy.
export route-policy route-policy
Optional
By default, routes to be advertised
are not filtered.
NOTE:
•
Route related attributes configured in VPN instance view are applicable to both IPv4 VPNs and IPv6
VPNs.
• You can configure route related attributes for IPv6 VPNs in both VPN instance view and IPv6 VPN view.
Those configured in IPv6 VPN view take precedence.
• A single vpn-target command can configure up to eight VPN targets. You can configure up to 64 VPN
targets for a VPN instance.
• You can define the maximum number of routes for a VPN instance to support, preventing too many
routes from being redistributed into the PE.
• Create a routing policy before associating it with a VPN instance. Otherwise, the device cannot filter the
routes to be received and advertised.
Configuring a tunneling policy for a VPN instance
To configure a tunneling policy for a VPN instance:
Step Command Remarks
1. Enter system view. system-view N/A
2. Create a tunneling policy and
enter tunneling policy view.
tunnel-policy tunnel-policy-name Required
3. Specify the tunnel selection
preference order and the
number of tunnels for load
balancing.
tunnel select-seq { cr-lsp | lsp } *
load-balance-number number
By default, only one tunnel is
selected (no load balancing) in this
order: LSP tunnel, CR-LSP tunnel.
4. Return to system view. quit N/A
5. Enter VPN instance view. ip vpn-instance vpn-instance-name Required
6. Enter IPv6 VPN view. ipv6-family Optional
7. Apply the tunneling policy to
the VPN instance.
tnl-policy tunnel-policy-name
By default, only one tunnel is
selected (no load balancing) in this
order: LSP tunnel, CR-LSP tunnel.