Configuration procedure – H3C Technologies H3C SR8800 User Manual

Page 187

176

Figure 44 Network diagram

Configuration procedure

Configure an IGP (such as OSPF) on the MPLS backbone. (Details not shown)

Configure Spoke-PE 1.
# Configure basic MPLS.

system-view

[Sysname] sysname Spoke-PE1

[Spoke-PE1] interface loopback 0

[Spoke-PE1-LoopBack0] ip address 1.1.1.9 32

[Spoke-PE1-LoopBack0] quit

[Spoke-PE1] mpls lsr-id 1.1.1.9

[Spoke-PE1] mpls

[Spoke-PE1–mpls] quit

[Spoke-PE1] mpls ldp

[Spoke-PE1-mpls-ldp] quit

# Configure basic MPLS on the interface connected to Hub-PE.

[Spoke-PE1] interface GigabitEthernet 3/1/1

[Spoke-PE1-GigabitEthernet3/1/1] ip address 10.1.1.1 24

[Spoke-PE1-GigabitEthernet3/1/1] mpls

[Spoke-PE1-GigabitEthernet3/1/1] mpls ldp

[Spoke-PE1-GigabitEthernet3/1/1] quit

# Configure the remote LDP session with Hub-PE.

[Spoke-PE1] mpls ldp remote-peer 1

[Spoke-PE1-mpls-remote-1] remote-ip 3.3.3.9

[Spoke-PE1-mpls-remote-1] quit

# Enable L2VPN and MPLS L2VPN.

[Spoke-PE1] l2vpn

[Spoke-PE1-l2vpn] mpls l2vpn

[Spoke-PE1-l2vpn] quit

This manual is related to the following products: