Configuration procedure – H3C Technologies H3C SR8800 User Manual

Page 184

173

Configuration procedure

Configure the IGP protocol (such as OSPF) on the MPLS backbone. (Details not shown)

Configure UPE.
# Configure basic MPLS.

system-view

[Sysname] sysname UPE

[UPE] interface loopback 0

[UPE-LoopBack0] ip address 1.1.1.9 32

[UPE-LoopBack0] quit

[UPE] mpls lsr-id 1.1.1.9

[UPE] mpls

[UPE-mpls] quit

[UPE] mpls ldp

[UPE-mpls-ldp] quit

# Configure basic MPLS on the interface connected to NPE 1.

[UPE] interface GigabitEthernet 3/1/1

[UPE-GigabitEthernet3/1/1] ip address 10.1.1.1 24

[UPE-GigabitEthernet3/1/1] mpls

[UPE-GigabitEthernet3/1/1] mpls ldp

[UPE-GigabitEthernet3/1/1] quit

# Configure the remote LDP session.

[UPE] mpls ldp remote-peer 1

[UPE-mpls-remote-1] remote-ip 2.2.2.9

[UPE-mpls-remote-1] quit

# Enable L2VPN and MPLS L2VPN.

[UPE] l2vpn

[UPE-l2vpn] mpls l2vpn

[UPE-l2vpn] quit

# Configure the VPLS instance aaa that uses LDP signaling.

[UPE] vsi aaa static

[UPE-vsi-aaa] pwsignal ldp

[UPE-vsi-aaa-ldp] vsi-id 500

[UPE-vsi-aaa-ldp] peer 2.2.2.9

[UPE-vsi-aaa-ldp] quit

[UPE-vsi-aaa] quit

# Configure interface GigabitEthernet 3/1/2 and bind VPLS instance aaa to the interface.

[UPE] interface GigabitEthernet 3/1/2

[UPE-GigabitEthernet3/1/2] l2 binding vsi aaa

[UPE-GigabitEthernet3/1/2] quit

Configure NPE 1.
# Configure basic MPLS.

system-view

[Sysname] sysname NPE1

[NPE1] interface loopback 0

[NPE1-LoopBack0] ip address 2.2.2.9 32

[NPE1-LoopBack0] quit

This manual is related to the following products: