H3C Technologies H3C SR8800 - Manual (Page 42)

31
Task Command Remarks
Display information about
LDP-enabled interfaces.
display mpls ldp interface [ all [ verbose ] |
[ vpn-instance vpn-instance-name ]
[ interface-type interface-number | verbose ] ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view
Display information about LDP
peers.
display mpls ldp peer [ all [ verbose ] |
[ vpn-instance vpn-instance-name ] [ peer-id |
verbose ] ] [ | { begin | exclude | include }
regular-expression ]
Available in any view
Display information about remote
LDP peers.
display mpls ldp remote-peer [ remote-name
remote-peer-name ] [ | { begin | exclude |
include } regular-expression ]
Available in any view
Display information about LDP
sessions between LDP peers.
display mpls ldp session [ all [ verbose] |
[ vpn-instance vpn-instance-name ] [ peer-id |
verbose ] ] [ | { begin | exclude | include }
regular-expression ]
Available in any view
Display statistics information about
all LSP sessions.
display mpls ldp session all statistics [ |
{ begin | exclude | include }
regular-expression ]
Available in any view
Display information about LSPs
established by LDP.
display mpls ldp lsp [ all | [ vpn-instance
vpn-instance-name ] [ dest-addr
mask-length ] ] [ | { begin | exclude |
include } regular-expression ]
Available in any view
Display information about CR-LSPs
established by CR-LDP.
display mpls ldp cr-lsp [ lspid lsr-id lsp-id ] [ |
{ begin | exclude | include }
regular-expression ]
Available in any view
NOTE:
In these display commands, vpn-instance vpn-instance-name specifies an LDP instance. For information
about LDP instances, see the chapter “Configuring MPLS L3VPN.”
Clearing MPLS statistics
Task Command Remarks
Clear MPLS statistics for a specific
MPLS interface or all MPLS
interfaces.
reset mpls statistics interface { interface-type
interface-number | all }
Available in user view
Clear MPLS statistics for a specific
LSP or all LSPs. reset mpls statistics lsp { index | all | name
lsp-name }
Available in user view