H3C Technologies H3C SR8800 - Manual (Page 220)

209
Reply from 100.1.1.2: bytes=56 Sequence=2 ttl=255 time=60 ms
Reply from 100.1.1.2: bytes=56 Sequence=3 ttl=255 time=10 ms
Reply from 100.1.1.2: bytes=56 Sequence=4 ttl=255 time=70 ms
Reply from 100.1.1.2: bytes=56 Sequence=5 ttl=255 time=60 ms
--- 100.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 10/76/180 ms
Example for configuring SVC MPLS L2VPN
Network requirements
As shown in Figure 51 , the CEs are connected to PEs through GigabitEthernet interfaces.
Establish an SVC MPLS L2VPN between CE 1 and CE 2.
Figure 51 Network diagram
Device Interface IP address Device Interface IP address
CE 1 GE4/1/1 100.1.1.1/24 P Loop0 192.4.4.4/32
PE 1 Loop0 192.2.2.2/32 GE4/1/1 10.2.2.2/24
GE4/1/2 10.1.1.1/24 GE4/1/2 10.1.1.2/24
CE 2 GE4/1/1 100.1.1.2/24 PE 2 Loop0 192.3.3.3/32
GE4/1/1 10.2.2.1/24
Configuration procedure
The main steps are the following two:
• Configure MPLS basic forwarding capability on the PEs and P router. This includes configuring the
LSR ID, enabling MPLS and LDP, and running IGP (OSPF in this example) between PE 1, the P router,
and PE 2 to establish LSPs.
• Establish an SVC MPLS L2VPN connection. This includes enabling MPLS L2VPN on PE 1 and PE 2
and establishing an SVC connection and specifying the VC labels.
The detailed configuration procedure is as follows:
1. Configure CE 1.
system-view
[Sysname] sysname CE1
[CE1] interface GigabitEthernet 4/1/1