H3C Technologies H3C SR8800 - Manual (Page 67)

56
Task Remarks
Configuring MPLS TE basic capabilities Required
Configuring DiffServ-aware TE Optional
Configuring an
MPLS TE tunnel
Creating MPLS TE tunnel over static CR-LSP Required
Use either approach
Configuring MPLS TE tunnel with dynamic signaling protocol
Configuring RSVP-TE advanced features Optional
Tuning CR-LSP setup Optional
Tuning MPLS TE tunnel setup Optional
Configuring traffic forwarding
Forwarding traffic along MPLS TE tunnels
using static routes
Required
Use either approach
Forwarding traffic along MPLS TE tunnels
through automatic route advertisement
Configuring traffic forwarding tuning parameters Optional
Configuring CR-LSP backup Optional
Configuring FRR Optional
Inspecting an MPLS TE tunnel Optional
Configuring protection switching Optional
Configuring MPLS TE basic capabilities
MPLS TE basic capabilities are essential to MPLS TE feature configurations. After configuring the basic
capabilities, you need to make other configurations in order to use MPLS TE depending on the actual
requirements.
Configuration prerequisites
Before the configuration, do the following:
• Configure static routing or IGPs to make sure all LSRs are reachable.
• Configure MPLS basic capabilities.
NOTE:
For configuration information about MPLS basic capability, see MPLS Configuration Guide.
Configuration procedure
To configure MPLS TE basic capabilities:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter MPLS view. mpls N/A
3. Enable global MPLS TE. mpls te Disabled by default