AMETEK Compact i/iX Series Software Manual - Manual (Page 95)

User Manual - Rev H California Instruments
Avionics Software 95
1.7 Steady State Frequency (see Designer Notes) 360 to 800 Hz Requirement fulfilled in 1.1 and 1.2
1.8 Frequency Modulation Per Figure 2 2 mins each test (360, 800Hz nominal) HVAC-18
2.0 Normal AC Transients
2.1 Voltage Transients 50ms Dropouts 800Hz and 360Hz HVAC-21-1
2.1 Voltage Transients Voltage Surge/Sag 3 times each, 800Hz and 360Hz HVAC-21-2
2.1 Voltage Transients Per Table B.2.1.1.1 2 times each HVAC-21-3
2.2 Voltage Spikes Per Figure 10 Requires additional equipment
2.3 Frequency Transients
2.3.1 Maximum Ramp Rate 100Hz/s up, 200Hz/s down 3 times each, 360Hz nominal HVAC-23
3.0 Abnormal AC Steady State
3.1 Individual Phase Voltage 190.0 to 268.0 Volts RMS Single Phase Unit Test HVAC-31-1
3.1 Individual Phase Voltage 190.0 to 268.0 Volts RMS Three Phase Unit Test HVAC-31-2
3.2 Average of Three-Phase Voltages 193.0 to 265.0 Volts RMS 5 mins each test HVAC-32
3.3 Abnormal Steady State Frequency (see Designer Notes) 360 to 800 Hz Requirement fulfilled in 1.7
4.0 Abnormal AC Transients
4.1 Voltage Transients Per Figure 5A Apply each transient 3x with 10s interval HVAC-41
4.2 Frequency Transients
4.2.1 Maximum Ramp Rate 100Hz/s up, 200Hz/s down Test procedure TBD
4.2.2 Transients Outside of Steady State Range Per Figure 6 Test procedure TBD
4.3 DC Content Per Figure 11 Test procedure TBD
SUPP Supplementary Transient Test Requirements Tests 1-7, Table 3.3.2-3A Tests performed at 360, 530, and 800 Hz HSUPP-1
SUPP Supplementary Transient Test Requirements Tests 8-14, Table 3.3.2-3A Tests performed at 360, 530, and 800 Hz HSUPP-2
SUPP Supplementary Transient Test Requirements Tests 15-20, Table 3.3.2-3A Tests performed at 360, 530, and 800 Hz HSUPP-3
SUPP Supplementary Transient Test Requirements Tests 21-27, Table 3.3.2-3A Tests performed at 360, 530, and 800 Hz HSUPP-4
SUPP Supplementary Transient Test Requirements Tests 28-34, Table 3.3.2-3A Tests performed at 360, 530, and 800 Hz HSUPP-5
SUPP Supplementary Transient Test Requirements Tests 35-40, Table 3.3.2-3A Tests performed at 360, 530, and 800 Hz HSUPP-6
SUPP Supplementary Transient Test Requirements Tests 41-47, Table 3.3.2-3A Tests performed at 360, 530, and 800 Hz HSUPP-7
SUPP Supplementary Transient Test Requirements Tests 48-53, Table 3.3.2-3A Tests performed at 360, 530, and 800 Hz HSUPP-8
SUPP Supplementary Transient Test Requirements Tests 54-62, Table 3.3.2-3A Tests performed at 360, 530, and 800 Hz HSUPP-9
SUPP Supplementary Transient Test Requirements Tests 63-74, Table 3.3.2-3A Tests performed at 360, 530, and 800 Hz HSUPP-10
SUPP Supplementary Transient Test Requirements Tests 1-6 Table 3.3.2-3B Tests performed at 360, 530, and 800 Hz HSUPP-11
SUPP Supplementary Transient Test Requirements Tests 7-12 Table 3.3.2-3B Tests performed at 360, 530, and 800 Hz HSUPP-12
SUPP Supplementary Transient Test Requirements Tests 13-15 Table 3.3.2-3B Tests performed at 360, 530, and 800 Hz HSUPP-13