AMETEK Compact i/iX Series Software Manual - Manual (Page 58)

User Manual – Rev H California Instruments
58 Avionics Software
No. Description 115
VAC
235
VAC
No. 28 VDC Tests
Description Type
I DC
Type
II DC Type
III DC
Type
IV DC
Type
V DC
Type
VI DC
1.8 Frequency Modulation  C
9.1.1
13.1
Steady State Voltage  
2.1 Voltage Transients  C 9.1.2 Steady State Voltage  N/A
2.2 Voltage Spikes X X 9.2.1
Differential Mode
Voltage Ripple
TBD N/A
2.3.1 Maximum Ramp Rate  C
9.2.2
13.3
Differential Mode
Ripple Components
X X
2.3.2 Frequency Transients  C
9.3.1
13.2
Common Mode
Voltage
TBD 
2.4
Multiple Stroke Power
Interruptions
 C 9.3.2
Common Mode
Frequency
X N/A
3.1
Abnormal Individual
Phase Voltage
 C
10.1
14.1
Voltage Transients  
3.2
Abnormal Average of
Three Phase Voltages
 C
11.1
15.1
Abnormal Steady State
Voltage
 
4.1
Abnormal Voltage
Transients
 C 11.2.1
Abnormal Differential
Mode Ripple
X N/A
4.2.1
Abnormal Maximum
Ramp Rate
 C
12.1
16.1
Abnormal Voltage
Transients
 
4.2.2
Abnormal Frequency
Transients
C C
4.3 Abnormal DC Content P C, P
Supp
Supplementary
Transient Tests

C
Table 4-2: -B787 Option i/iX Test Coverage
Note that the iX Series does not support 800 Hz testing at more than 150Vrms. Consequently, all
230V nominal tests for A(NF) and A(WF) categories are not supported. Some A(CF) tests requiring
more than 300V output are also unavailable due to hardware limitations of the iX Series power
source.