AMETEK Compact i/iX Series Software Manual - Manual (Page 11)

User Manual - Rev H California Instruments
Avionics Software 11
2.2 Test Control Window
Figure 2-1: 160 Option Test Selection Screen.
To access an avionics option, select the option from the Applications menu of the Gui main screen or
click on the appropriate button in the toolbar. The Tables Control window will open selecting the last
power group that was selected in a previous instance. It may still be necessary to select the desired
power group first however. Also verify that the selected power group on the screen is the correct one
for the EUT being tested.
The avionics tests can be operated from the test control screen. This screen contains three main tabs
located along the top edge of the window. The following tabs are available. Click on the tab name for
additional help on how to use each tab.
Tab Description
Test Selection This tab allows the operator to select the library of test files to use (Select
Test) and the relevant Power group. It also displays the AC power source
settings that are in effect on the right hand side. Available power group
selections are shown below the test selection field. The table shown at the
bottom of this tab shows the available test sections that can be selected.
Test Control This tab provides information on the test sequence that is presently selected
and also contains the execution controls. It shows the progress of any test that
is executing.
EUT Performance
Measurements This tab may be used to display EUT performance data as measured by the
power source‟s advanced data acquisition system. If the source used does not
support advanced measurement function such as waveform capture and FFT,
some of the information in this tab may not be displayed.
In addition to the three tab controls, the left pane of the test control window contains a set of output
on/off control buttons and a print button. The on/off buttons may be used to open or close the output