Lx/ls series –do160 option limitations – AMETEK Compact i/iX Series Software Manual User Manual
Page 29
User Manual - Rev H
California Instruments
Avionics Software
29
3.1.3
Lx/Ls Series
–DO160 Option Limitations
The extent of coverage of the
–160 option as implemented on the Lx/Ls Series platform is shown in
the table below. Tests marked with an „x‟ generally require additional hardware to be used. Tests
marked „N/A‟ are not applicable to the corresponding table. Tests marked with a „
‟ are covered by
the
–160 option. Tests marked with a „P‟ require arbitrary waveform capability, which is available on
Lx models and Ls models with the
–ADV option only. Note that some voltage surge tests may require
optional output voltage ranges on the Lx/Ls and may not be supported on the standard voltage range.
DC tests are NOT supported by the Lx/Ls Series
No.
115V Tests
Description
Table
A(CF)
Table
A(NF)
Table
A(WF)
No.
28 VDC Tests
Description
Table
ADC
Table
BDC
Table
ZDC
16.5.1.1
Voltage and
Frequency
16.6.1.1
Voltage
X
X
X
16.5.1.2
Voltage Modulation
16.6.1.2
Ripple Voltage
X
X
X
16.5.1.3
Frequency
Modulation
16.6.1.3
Momentary Power
Interruptions
X
X
X
16.5.1.4
Momentary Power
Interruptions
16.6.1.4
Normal Surge
Voltage
X
X
X
16.5.1.5.1
Normal Surge
Voltage
16.6.1.5
Engine Starting
Under Voltage
X
X
X
16.5.1.5.2
Normal Frequency
Transients
N/A
N/A
16.6.2.1
Abnormal Voltage
X
X
X
16.5.1.6
Normal Frequency
Variations
N/A
16.6.2.2
Low Voltage
Conditions
X
X
X
16.5.1.7
Voltage DC
Content
X
X
X
16.6.2.3
Momentary Under
Voltage Operation
X
X
X
16.5.1.8
Voltage Distortion
P
P
P
16.6.2.4
Abnormal Voltage
Surge
X
X
X
16.5.2.1
Abnormal Voltage
and Frequency
16.5.2.2
Momentary Under
Voltage Operation
16.5.2.3.1
Abnormal Surge
Voltage
16.5.2.3.2
Abnormal
Frequency
Transient
N/A
N/A
Table 3-7: -160 Option Ls/Lx Test Coverage, 115VAC and 28VDC