AMETEK Compact i/iX Series Software Manual - Manual (Page 117)

User Manual - Rev H California Instruments
Avionics Software 117
Test No. Section Subject Test Limits Comment File Ref.
SAC603 Phase Reversal N/A to Rev C
5.3.4.2 Table TAC:
Test No. Section Subject Test Limits Comment File Ref.
TAC101 Three Phase Load and Current Harmonic Measurements 115V RMS, 400 Hz CTAC101
TAC102 Steady State Limits for Voltage (Including Unbalance) and Frequency
1 Balanced Phases 108V to 118V RMS, 393 to 407 Hz Apply for 30 mins each test CTAC102-1
2 Unbalanced Phases 108V to 118V RMS, +/- 3V Unbalance Apply for 30 mins each test CTAC102-2
TAC103 Voltage Phase Difference Phase B 116 to 124 degrees Apply for 30 mins each test CTAC103
TAC104 Voltage Modulation
1 115V Nominal Test 115V RMS, 2.5V RMS mod Apply for 10+ mins CTAC104-1
2 109V Nominal Test 109V RMS, 2.5V RMS mod Apply for 10+ mins CTAC104-2
3 117V Nominal Test 117V RMS, 2.5V RMS mod Apply for 10+ mins CTAC104-3
TAC105 Frequency Modulation
1 400 Hz Nominal Test 400 Hz, +/-5 Hz mod Apply for 10+ mins CTAC105-1
2 395 Hz Nominal Test 395 Hz, +/-5 Hz mod Apply for 10+ mins CTAC105-2
3 405 Hz Nominal Test 405 Hz, +/-5 Hz mod Apply for 10+ mins CTAC105-3
TAC106 Voltage Distortion Spectrum Requires Additional Equipment
TAC107 Total Voltage Distortion Voltage Distortion Factor 0.05 Apply for 30 mins CTAC107
TAC108 DC Voltage Component
1 Positive DC Offset 115V RMS + .10V DC Apply for 30 mins CTAC108-1
2 Negative DC Offset 115V RMS - .10V DC Apply for 30 mins CTAC108-2
TAC109 Normal Voltage Transients 180V RMS to 80V RMS
1 Overvoltage Transients Peak voltage 180V RMS Table TAC109-3 AA-GG CTAC109-1
2 Undervoltage Transients Low voltage 80V RMS Table TAC109-3 HH-LL CTAC109-2
3 Combined Transient 180V RMS to 80V RMS Table TAC109-3 MM CTAC109-3
4 Repetitive Normal Voltage Transient Test 90V RMS to 140V RMS Run transient for 30 mins CTAC109-4
TAC110 Normal Frequency Transients 375 Hz to 425 Hz
1 Overfrequency Transients High Frequency 425 Hz Table TAC110-3 AA-DD CTAC110-1
2 Underfrequency Transients Low Frequency 375 Hz Table TAC110-3 EE-HH CTAC110-2
3 Combined Transient 375 Hz to 425 Hz Table TAC110-3 II CTAC110-3
TAC201 Power Interrupt 0V for 50 msec Table TAC201-2 A-L CTAC201
TAC301 Abnormal Steady State Limits for Voltage and Frequency 100V RMS to 125V RMS, 380 Hz to 420 Hz Apply for 30 mins CTAC301
TAC302 Abnormal Voltage Transients 45V RMS to 180V RMS
1 Overvoltage Transients Peak voltage 180V RMS Table TAC302-3 AA-GG CTAC302-1
2 Undervoltage Transients Low voltage 45V RMS Table TAC302-3 HH-NN CTAC302-2
3 Combined Transient 45V RMS to 180V RMS Table TAC302-3 OO CTAC302-3
TAC303 Abnormal Frequency Transients 320 Hz to 480 Hz Table TAC303-3 AA-EE CTAC303
TAC401 Emergency Steady State Limits for Voltage and Frequency 104V to 122V RMS, 360 to 440 Hz Apply for 30 mins each test CTAC401
TAC501 No Tests N/A to AC Utilization Equipment
TAC601 Power Failure (Three Phase) 0V for 7 seconds Table TAC601-2 A-D CTAC601
TAC602 One Phase and Two Phase Power Failures
1 One Phase Power Failures 0V for 7 seconds Table TAC602-2 A-F CTAC602-1