AMETEK Compact i/iX Series Software Manual - Manual (Page 16)

User Manual – Rev H California Instruments
16 Avionics Software
Control / Display Description
VSlew A Voltage slew rate in V/sec
Func A Waveform function. Default is SINE for AC mode and DC for DC
mode. Arbitrary waveform can be used in AC mode if this
capability is supported by the power source.
Volt B Test voltage for phase/output B in Vrms or Vdc depending on
mode.
VSlew B Voltage slew rate in V/sec
Func B Waveform function. Default is SINE for AC mode and DC for DC
mode. Arbitrary waveform can be used in AC mode if this
capability is supported by the power source.
Volt C Test voltage for phase/output C in Vrms or Vdc depending on
mode.
VSlew C Voltage slew rate in V/sec
Func C Waveform function. Default is SINE for AC mode and DC for DC
mode. Arbitrary waveform can be used in AC mode if this
capability is supported by the power source.
Dwell Dwell time in seconds.
Loop Repeat count for each step. Default is 1.
Link Number of subsequent rows that are linked to this step. This
function is required to implement complex transients that require
multiple steps with zero time skew. When set to a value other
than blank or “0”, subsequent rows are considered part of the
same test step for single step or loop on step execution modes.
Rows that are linked will not become highlighted when executed.
PhsB Phase angle of phase B, only visible if phase angle is changed.
PhsC Phase angle of phase C, only visible if phase angle is changed.
Comment A comment about the specific test step.