Altera ALTDQ_DQS2 - Manual (Page 61)

Instantiating the ALTDLL IP Core
To instantiate the ALTDLL IP core, follow these steps:
1. In the IP Catalog (Tools > IP Catalog), locate and double-click the name of the IP core to customize.
The parameter editor appears.
2. Specify a top-level name for your custom IP variation. This name identifies the IP core variation files
in your project. If prompted, also specify the target Altera device family and output file HDL
preference. Click OK.
3. On the Parameter Settings tab, on the General page, specify the parameters as shown in the following
figure.
Figure 22: ALTDLL Parameter Settings Tab
4. Click Finish.
Instantiating ALT_OCT IP Core
1. In the IP Catalog (Tools > IP Catalog), locate and double-click the name of the IP core to customize.
The parameter editor appears.
2. Specify a top-level name for your custom IP variation. This name identifies the IP core variation files
in your project. If prompted, also specify the target Altera device family and output file HDL
preference. Click OK.
3. On the Parameter Settings tab, on the General page, specify the parameters as shown in the following
figure.
UG-01089
2014.12.17
Instantiating the ALTDLL IP Core 61
ALTDQ_DQS2 IP Core User Guide Altera Corporation
Send Feedback