beautypg.com

Calibrating the system – EXFO IQS-12004B DWDM Passive Component Test System for IQS-500 User Manual

Page 85

background image

DWDM Passive Component Test System

73

6

Calibrating the DWDM Passive

Component Test System

Calibrating the System

After selecting the setup parameters, the main window is displayed
(see figure below). Normally, the application brings you to this step
automatically. If necessary, you can go directly to the Calibration step. For
information on accessing a step, see Accessing a Specific Test Step on
page 34.

Note: The system has been calibrated at the factory and upon installation.

Recommended recalibration procedures are explained in the following
pages.

To perform a system calibration, click OK as indicated on the screen.