EXFO IQS-12004B DWDM Passive Component Test System for IQS-500 - Manual (Page 222)

Automating or Remotely Controlling the System
210 IQS-12004B
IQS-12004B DWDM Passive Component Test System (Standard) COM Error Messages
ErrOptimizeBefore Unable to change the polarization state because the power
optimization has not been performed. Please optimize the
power.
ErrOrlResultCurve Invalid ORL result curve.
ErrPmValue Invalid power meter value.
ErrPmValueOver Invalid power meter value (over range).
ErrPmValueUnder Invalid power meter value (under range).
ErrPowerMin_PM Unable to perform an acquisition because the power at the
power meter input is too low. Please check your
connection.
ErrPowerMin_Wrm Unable to perform an acquisition because the power at the
WRM input is too low. Please check your connection.
ErrPrevInstance A previous object instance is already running. Only one
instance can run on each computer.
ErrRefIlBefore Unable to perform an acquisition because the IL reference
has not been taken. Please take IL reference.
ErrRefOrlMandrelBefore Unable to perform an acquisition because the ORL
reference has not been taken. Please take ORL reference.
ErrScanRange Invalid scan range. The acquisition has stopped.
ErrSimData Cannot find simulator data file.
ErrSourceNotEnabled The sweep cannot be performed. The laser source is turned
on.
ErrSweepSpan Unable to determine a sweep span that fits with the sweep
time.
ErrSynchro Power meter synchronization error. The acquisition has
stopped.
Error Number Description