EXFO IQS-12004B DWDM Passive Component Test System for IQS-500 - Manual (Page 29)

DWDM Passive Component Test System 17
3 Getting Started with Your
DWDM Passive Component
Test System
This chapter contains a description of hardware components and modules
used in the system, information on how to install hardware components
and how to install and start the IQS-12004B DWDM Passive Component
Test System software. You will also find a description of the utility to
organize test files as well as a description of the application main window.
Inserting and Removing Test Modules
To insert a module into the controller or expansion unit:
1. Exit IQS Manager and turn off all your units.
2. Remove the protective cover from the desired unused module slot.
2a. Pull the retaining screw knob firmly towards you and release the
bottom of the cover.
2b. Gently pull the top of the protective cover downwards, to remove
it from the unit grooves.
C
AUTION
Never insert or remove a module while the controller unit and its
expansion units are turned on. This will result in immediate and
irreparable damage to both the module and unit.