beautypg.com

EXFO IQS-12004B DWDM Passive Component Test System for IQS-500 User Manual

Page 215

background image

Automating or Remotely Controlling the System

DWDM Passive Component Test System

203

Configuring Your DWDM Passive Component Test System as a GPIB Controller

2. Remove the NI-Device 1.3 Standard software as follows:

2a. From the Control Panel, double-click the Add/Remove Programs

icon.

2b. Select the Change or Remove Programs function tab.

2c. From the list of currently installed programs, select NI-Device 1.3

Standard and click Remove.

3. Install the NI-488.2 1.70 software as follows:

3a. Insert the installation CD-ROM in the drive.

3b. On the Windows taskbar, click Start and select Run.

3c. Use the Browse button to find the GPIB Controller folder on the

CD-ROM, then select setup.exe.

3d. Click OK to start the installation. The installation is relatively

straightforward: click Next until you reach the end (Finish).