EXFO IQS-12004B DWDM Passive Component Test System for IQS-500 - Manual (Page 212)

Automating or Remotely Controlling the System
200 IQS-12004B
Configuring Your DWDM Passive Component Test System as a GPIB Controller
Configuring Your DWDM Passive Component
Test System as a GPIB Controller
At time of purchase, your IQS-12004B controller unit is configured to be
used as a GPIB device. However, it is possible to configure it as a GPIB
controller.
Note: The following procedure is based on Windows 2000.
To configure your IQS-12004B controller unit as a GPIB controller:
1. Uninstall the GPIB card as follows:
1a. On the Windows taskbar, click Start and select
Settings > Control Panel.
1b. From the Control Panel, double-click the Add/Remove
Hardware icon.
1c. From the welcome step, click Next.
1d. From the Choose a Hardware Task step, select the
Uninstall/Unplug a device option and click Next.
I
MPORTANT
Do not remove the GPIB card from the IQS-12004B controller unit.