EXFO IQS-12004B DWDM Passive Component Test System for IQS-500 - Manual (Page 199)

Automating or Remotely Controlling the System
DWDM Passive Component Test System 187
GPIB Specific Commands—Quick Reference
GPIB Specific Commands—Quick Reference
The following table contains a summary of the IQS-12004B DWDM Passive
Component Test System specific commands. If you need more information
about these specific commands, see Specific Commands on page 233.
Command Parameter/Response Description
INIT INIT -- This command performs an
initialization of all IQS modules.
INIT? (0 | 1) The response to this query indicates
if an initialization of the modules
has been performed.
SIMU <0 | 1> This command sets the system to
simulation mode.
SIMU? (0 | 1) The response to this query indicates
if the system is in simulation mode.
CONF AVAC? (999) The response to this query indicates
the number of available channels in
the system.
CHAN <999 > This command sets the number of
channels to test.
CHAN? (999) The response to this query indicates
the number of channels to test.
ACQT <1 | 2 | 3 | 4> This command sets the acquisition
type.
ACQT? (1 | 2 | 3 | 4) The response to this query indicates
the acquisition type.
CONF KIL <0 | 1> This command keeps IL curves for
all SOP, when a PDL acquisition has
been performed.
KIL? (0 | 1) The response to this query indicates
if IL curves are kept for all SOP.