Belt control; tensioner and idler pulleys – Cub Cadet SLTX1000 Series User Manual
Page 78
LTX Tractors
72
Belt control; tensioner and idler pulleys
NOTE: The V-idler pulleys can be removed from
below using a 1/2” wrench, with no disas-
sembly beyond removing the cutting deck.
See Figure 5.35.
NOTE: Confirm that the parking brake is released
before starting work.
1.
Remove the mowing deck.
2.
Remove the fenders by following the steps
described in Chapter 4: Body Panels.
3.
Disconnect the rod that joins the arm at the left side
of the clutch/brake shaft to the drive belt tensioner
pulley bracket. See Figure 5.36.
•
Remove and discard the cotter pin to discon-
nect the rod.
4.
Disconnect the extension spring that pulls on the
bracket to tension the drive belt. See Figure 5.37.
Figure 5.35
V-sheave
pulleys
Figure 5.36
Clutch/brake shaft Rod Bracket
Figure 5.37
Extension spring
Mounting points