Cub Cadet SLTX1000 Series - Manual (Page 76)

LTX Tractors
70
NOTE: The pedal shaft support straps are two dif-
ferent sizes. The smaller strap holds-up the
left (brake pedal) end of the pedal shaft
assembly. The larger strap holds-up the right
(drive control pedal) end of the pedal shaft
assembly. See Figure 5.31.
14. Inspect the pedal shaft components individually.
Replace any parts that are worn or damaged.
See Figure 5.32.
• The plastic bushings that fit between the two
pedal shafts should be replaced any time they
are removed. Lubricate them with a dry PTFE
or graphite-based lubricant on assembly. NOT
grease.
• Replace the push cap and all removed cotter
pins with new parts.
15. Install the pedal shaft assembly by reversing the
steps used to remove it, then install the fenders.
15a. Lubricate the points where the pedal shafts
meet the frame with a good quality lithium-
based grease. See Figure 5.33.
Figure 5.31
Left side strap Right side strap
Figure 5.32
Clutch/brake pedal shaft Push cap
Drive pedal shaft Pedal shaft
support strap
Bushings
Figure 5.33