Cub Cadet SLTX1000 Series - Manual (Page 23)

Steering
17
Axles
NOTE: The left and right axle have a “L” or a “R” stamped
on the end of the shaft for identification.
See Figure 3A.4.
1. Jack up the front end of the tractor and securely place
on jack stands.
2. Remove the front wheel by popping the hub cap off
with a flat head screw driver.
3. Remove the cotter pin and the castellated washer.
See Figure 3A.5.
NOTE: When installing the wheel, install a new cotter pin
in between the uprights of the castellated washer.
4. Remove the nut holding the drag link to the steering
block using a 1/2” and 9/16” wrench.
See Figure 3A.6.
Figure 3A.4
Identification mark
Figure 3A.5
Castellated washer
Figure 3A.6
1/2” wrench
9/16” wrench