Cub Cadet SLTX1000 Series - Manual (Page 231)

Maintenance Intervals
225
Air filter and foam pre-cleaner
A dirty air filter and/or foam pre-cleaner can reduce engine power, increase fuel consumption and make starting
more difficult.
The foam pre-cleaner should be checked before each use and cleaned every 25 hours.
The air filter should be cleaned before each use and replaced every two months or 50 hours of use.
Refer the engine manufacturer’s service manual for the proper procedure access the air filter.
To clean a pre-cleaner:
1. Remove the pre-cleaner following the steps described by the engine manufacturer.
2. The foam pre clean should be cleaned by:
2a. Wash the foam filter in warm soapy water.
2b. Rinse it and let it air dry.
IMPORTANT: Always replace a damaged filter.
NOTE: If the pre-cleaner does not directly contact the paper element air filter, work a few drops of light oil into
the pre-cleaner before installation. If the pre-cleaner directly contacts the paper air filter, do not oil the
pre-cleaner, as the oil may wick into the air filter, reducing the air flow through the air filter.
*These filters may vary with the engine models and individual filter designs.